25AA640-ESLASHP datasheet(10/24 Pages) MICROCHIP

10 / 24 page

25AA640/25LC640

DS21223G-page 10

 2004 Microchip Technology Inc.

3.5

Read Status Register Instruction

(RDSR)

The Read Status Register instruction (RDSR) provides

access to the Status register. The Status register may

be read at any time, even during a write cycle. The

Status register is formatted as follows:

The Write-In-Process (WIP) bit indicates whether the

25XX640 is busy with a write operation. When set to a

‘1’, a write is in progress, when set to a ‘0’, no write is

in progress. This bit is read-only.

The Write Enable Latch (WEL) bit indicates the status

of the write enable latch. When set to a ‘1’, the latch

allows writes to the array and Status register, when set

to a ‘0’, the latch prohibits writes to the array and Status

the WREN or WRDI commands regardless of the state

of write protection on the Status register. This bit is

read-only.

The Block Protection (BP0 and BP1) bits indicate

which blocks are currently write-protected. These bits

are set by the user issuing the WRSR instruction. These

bits are nonvolatile.

See Figure 3-6 for RDSR timing sequence.

FIGURE 3-6:

READ STATUS REGISTER TIMING SEQUENCE

654

WPEN

BP1

BP0

WEL

WIP

1011

1314

765

Instruction

Data from Status Register

High-impedance

SCK

4567

25AA640-E/P bảng dữ liệu(PDF) 10 Page - Microchip Technology

25AA640-E/P bảng dữ liệu(HTML) 10 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

bảng dữ liệu tải về

Link URL