MP2000DJ datasheet(3/3 Pages) MPS

3 / 3 page

EV2000DJ-00A – LOW INPUT VOLTAGE, 150MA LINEAR REGULATOR EV BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV2000DJ-00A Rev. 1.0

www.MonolithicPower.com

9/26/2005

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

PRINTED CIRCUIT BOARD LAYOUT

Figure 1—Top Silk Layer

Figure 2—Top Layer

QUICK START GUIDE

The output voltage of this board is set to 1.2V. The EN pin is connected to ground with a 10kΩ resistor

for automatic startup. You can connect EN to VIN to disable the MP2000.

1. Attach the positive and negative ends of the load to the VOUT and GND pins, respectively.

2. Attach the input voltage (1.35V ≤ VIN ≤ 6V) and input ground to the VIN and GND pins,

respectively.

3. The default resistor values on the board are R1=28.7kΩ and R2=20kΩ. Changing these resistor

values will change the output voltage. Use the following equation to determine resistor values

for different output voltages:

⎟

⎠

⎞

⎜

⎝

⎛ +

VOUT

T1 and T2 are test points for accurately measuring the input and output voltages.

MP2000DJ bảng dữ liệu(PDF) 3 Page - Monolithic Power Systems