CMR (x0CMR, x1CMR, x2CMR, x3CMR):

The CMR is a write only register, which when written into,

generates transient signals to perform load and reset operations

as described below:

CMR:

B7 B6 B5 B4 B3 B2 B1 B0

B0 = 0: Nop

= 1: Reset CNTR and sign to 0.

(Should not be combinedwith load_CNTR

operation).

B1 = 0: Nop

= 1: Load CNTR from PR. Affects all 24 bits. (Should

not be combined with reset_CNTR operation)

B2 = 0: Nop

= 1: Load OL from CNTR. Affects all 24 bits.

B3 = 0: Nop

= 1: Reset STR. Affects status bits corresponding to

carry, borrow, compare and index. Status

bits corresponding to count_enable, count

direction and sign are not affected.

B4 = 0: Nop.

1: Master reset. Resets MDR0, MDR1, STR, CNTR,

PR, OL, ISR and IMR

B5 = 0: Nop

1: Set sign bit

B6 = 0: Nop

1: Reset sign bit

B7 = 0: Nop.

1: Reset ISR bit for the selected axis

ISR:

The ISR is a trans-axis global register used to hold the

interrupt assertion status of all the axes. It is a 4-bit

read-only register with the following bit assignment.

ISR: B3

B2

B1

B0

B0

= 0: axis_0 interrupt cleared

= 1: axis_0 interrupt asserted

B1

= 0: axis_1 interrupt cleared

= 1: axis_1 interrupt asserted

B2

= 0: axis_2 interrupt cleared

= 1: axis_2 interrupt asserted

B3

= 0: axis_3 interrupt cleared

= 1: axis_3 interrupt asserted

An ISR bit gets set when the FLGa output of the

associated axis switches low. For this reason, in order

for the interrupt to be enabled for any axis, its associat-

ed FLGa output must be enabled. In addition, the

associated IMR bit must also be set for the interrupt to

be enabled.

An individual ISR bit can be cleared through its axis

relevant CMR register. The ISR is cleared upon

power-up.

A read of ISR produces a joint read of ISR and IMR

(interrupt mask register) with ISR occupying the upper

nibble and IMR occupying the lower nibble of the

databus.

7566R-121405-3