Features

MC13192 Technical Data, Rev. 3.2

2

Freescale Semiconductor

For more detailed information about MC13192 operation, refer to the MC13192 Reference Manual,

(MC13192RM).

Applications include, but are not limited to, the following:

•

Remote control and wire replacement in industrial systems such as wireless sensor networks

•

Factory automation and motor control

•

Energy Management (lighting, HVAC, etc.)

•

Asset tracking and monitoring

Potential consumer applications include:

•

Home automation and control (lighting, thermostats, etc.)

•

Human interface devices (keyboard, mice, etc.)

•

Remote control

•

Wireless toys

The transceiver includes a low noise amplifier, 1.0 mW power amplifier (PA), PLL with internal voltage

controlled oscillator (VCO), on-board power supply regulation, and full spread-spectrum encoding and

decoding. The device supports 250 kbps Offset-Quadrature Phase Shift Keying (O-QPSK) data in 2.0

MHz channels with 5.0 MHz channel spacing per the 802.15.4 Standard. The SPI port and interrupt request

output are used for receive (RX) and transmit (TX) data transfer and control.

2Features

•

Supports 250 kbps O-QPSK data in 5.0 MHz channels and full spread-spectrum encode and decode

(compatible with the 802.15.4 Standard)

•

Operates on one of 16 selectable channels in the 2.4 GHz band

•

RX sensitivity of <-92 dBm (typical) at 1.0% packet error rate

•

0 dBm nominal, programmable from -27 dBm to 4 dBm typical maximum output power

•

Recommended power supply range: 2.0 to 3.4 V

•

Buffered transmit and receive data packets for simplified use with low cost MCUs

•

Three power down modes for power conservation:

— < 1 µA Off current

— 1 µA Typical Hibernate current

— 35 µA Typical Doze current (no CLKO)

•

Four internal timer comparators available to supplement MCU resource

•

Programmable frequency clock output (CLKO) for use by MCU

•

Onboard trim capability for 16 MHz crystal reference oscillator eliminates need for external

variable capacitors and allows for automated production frequency calibration.

•

Seven general purpose input/output (GPIO) signals

•

Operating temperature range: -40 °C to 85 °C

•

Small form factor QFN-32 Package