TSL2580CS datasheet(15/53 Pages) OSRAM

15 / 53 page

Page 14

ams Datasheet

Document Feedback

[v1-00] 2016-Apr-05

TSL2580, TSL2581 − Principles O f Operation

SMBus and I²C Protocols

Each Send and Write protocol is, essentially, a series of bytes. A

byte sent to the TSL258x with the most significant bit (MSB)

equal to 1 will be interpreted as a COMMAND byte. The lower

four bits of the COMMAND byte form the register select address

(see Figure 26), which is used to select the destination for the

subsequent byte(s) received. The TSL258x responds to any

Receive Byte requests with the contents of the register specified

by the stored register select address.

The TSL2580 implements the following protocols of the SMB 2.0

specification:

• Send Byte Protocol

• Receive Byte Protocol

• Write Byte Protocol

• Write Word Protocol

• Read Word Protocol

• Block Write Protocol

• Block Read Protocol

The TSL2581 implements the following protocols of the Philips

Semiconductor I²C specification:

• I²C Write Protocol

• I²C Read (Combined Format) Protocol

When an SMBus Block Write or Block Read is initiated (see

description of Command Register), the byte following the

COMMAND byte is ignored but is a requirement of the SMBus

specification. This field contains the byte count (i.e. the number

of bytes to be transferred). The TSL2580 (SMBus) device ignores

this field and extracts this information by counting the actual

number of bytes transferred before the Stop condition is

detected.

TSL2580CS bảng dữ liệu(PDF) 15 Page - OSRAM GmbH