Type 8905

9 | 12

Visit product website 

Mechanical interfaces of the sensor cubes

All the fluidic backplanes for the sensor cubes have the same design. Thus any sensor cube can be plugged on any mechanical

interface.

The backplanes are connected to each other and feed the sensor cubes parallel with the power supply, the sample water and serial

büS connection.

Position of the lever

if no sensor cube is plugged in

if a sensor cube is plugged in

Electrical contacts

Security pin

Fluid outlet

Fluid inlet

Bayonet

Bayonet lever to the right

Fluid inlet and fluid outlet are closed and tight

Bayonet lever to the left

Fluid inlet and fluid outlet are open

Electrical contacts

Security pin

Fluid outlet

Fluid inlet

Bayonet

Bayonet lever to the right

Fluid inlet and fluid outlet are closed and tight

Bayonet lever to the left

Fluid inlet and fluid outlet are open

5.

Product accessories

Note:

To set up a device without a display, use the USB-büS interface, Type 8923 and the Bürkert Communicator Type 8920.

See Software manual Type 8920  for more information.

Accessories

No. Description

USB-büS interface Type 8923 (to be ordered

separately, see chapter “6.5. Ordering chart

accessories” on page 11)

1

2

3

4

7

8

10

9

5

6

1

Quick-Start

2

Power supply: 100…240 V AC/ 24 V DC 1 A and adaptors for power supply

worldwide use

3

büS terminating resistor on büS Y-splitter

4

5-pin M12 circular male connector wired on free end cable

5

büS connection cable with 5-pin M12 circular male connector, micro USB

B plug

6

büS adapter with 5-pin M12 circular male connector, A-coded to 5-pin M12

circular male connector, A-coded

7

büS stick (USB to büS/CANopen adaptor)

8

büS service cable with 5-pin M12 circular female connector, mini USB and

circular plug-in connectors for power supply

9

Magnetic key

10 CD - Communicator (30-day license without registration, update and licens-

ing over Bürkert home page)