Datasheet revision 1.0

www.chipquik.com

Chip Quik Removal Alloy (16ft. In 30-6.5in. Lengths) leaded

Product Highlights

Easily remove SMD parts with Chip Quik® removal alloy

Reduce heat and reduce damage to circuit boards and SMD parts during removal

Use with SMD291 flux

Specifications

Alloy:

Chip Quik®

Melting Point:

58°C (136°F)

Chip Quik® Instructions

1 Apply Chip Quik flux to all leads of SMD with syringe or flux applicator.

2

Melt Chip Quik low temperature alloy uniformly on all pins of SMD.

Maintain alloy in molten state long enough for complete reflow.

3 Lift chip from board with dental pick or vacuum pen.

4

Thoroughly clean site with swab dipped in flux while applying heat.

Clean thoroughly with alcohol pad.

1

© 1994-2015 Chip Quik® Inc.

S

SM

MD

D1

16

6