111

STEGO - PRODUCT CATALOGUE

ACCESSORIES

TECHNICAL DATA

Mounting

PG 29 thread with union nut

Torque

5 Nm

Material

plastic according to UL94 V-0, light grey

weather proof and UV light resistant according to UL746C (f1)

Sealing

sealing gasket NBR

Air interface

~ 1.5 cm²

Dimensions

Ø 65.5 x 30.5 mm

Fitting position

vertical¹

Operating/Storage temperature

-45 to +70 °C (-49 to +158 °F)

Approvals

EAC

Note

Material adheres to limit values in accordance with RoHS3

¹ Protection type is restricted to IP54 if fitting position of DA 084 is not vertical.

PRESSURE COMPENSATION DEVICE

DA 084 | IP55

Installation: Make cut-out Ø 37+1mm in enclosure wall and mount pressure compensation device with nut. Please make sure that

the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to

use two devices on opposite sides towards the top of the enclosure.

It has become more and more important to provide a protected enclosure environment for valuable and crucial

electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme

temperature variations. The specially designed pressure compensation device DA 084 permits a controlled change

in pressure and avoids the enterring of dust and water. The pressure compensation device is suitable for the use

in enclosures and housings in accordance with DIN EN 62208.

> High degree of protection

> Easy to install

Photo: Inside view

Art. No.

Protection type

1 packing unit

Weight (approx.)

08400.0-02-9002

IP55

2 pieces

62 g (31 g / piece)

111

TECHNICAL DATASHEET