AT83C24B datasheet(25/42 Pages) ATMEL

25 / 42 page

4234F–SCR–10/05

AT83C24

Table 11. INTERFACE (Interface Byte)

IODIS

CKSTOP

CARDRST

CARDC8

CARDC4

CARDCK

CARDIO

Bit Number

Bit Mnemonic

Description

This bit should not be set.

IODIS

Card I/O isolation

Set this bit to drive the CIO, CC4, CC8 pins according to CARDIO, CARDC4, CARDC8 respectively and to put

I/O, C4, C8 in Hi-Z. This can be used to have the I/O, and C4 and C8 pins of the host communicating with

another AT83C24 interface, while CIO, CC4 and CC8 are driven by software (or if the card is in standby or

power-down modes).

Clear this bit to drive the I/O/CIO, C4/CC4 and C8/CC8 pins according to each other. This can be used to activate

asynchronous cards.

The reset value is 1.

CKSTOP

CARD Clock Stop

Set this bit to stop CCLK according to CARDCK. This can be used to set asynchronous cards in power-down

mode (GSM) or to drive CCLK by software.

Clear this bit to have CCLK running according to CKS. This can be used to activate asynchronous cards.

Note:

1. When this bit is changed a special logic ensures that no glitch occurs on the CCLK pin

and actual configuration changes can be delayed by half a period to two periods of

CCLK.

2. CKSTOP must be set before switching on the DC/DC with VCARD[1:0].

The reset value is 1.

CARDRST

Card Reset

Set this bit to enter a reset sequence according to ART bit value.

Clear this bit to drive a low level on the CRST pin.

The reset value is 0.

CARDC8

Card C8

Set this bit to drive the CC8 pin High with the on-chip pull-up (according to IODIS bit value). The pin can then be

an input (read in STATUS register).

Clear this bit to drive a low level on the CC8 pin (according to IODIS bit value).

The reset value is 0.

CARDC4

Card C4

Set this bit to drive the CC4 pin High with the on-chip pull-up (according to IODIS bit value). The pin can then be

an input (read in STATUS register).

Clear this bit to drive a low level on the CC4 pin (according to IODIS bit value).

The reset value is 0.

CARDCK

Card Clock

Set this bit to set a high level on the CCLK pin (according to CKSTOP bit value).

Clear this bit to drive a low level on the CCLK pin.

The reset value is 0.

CARDIO

Card I/O

Set this bit to drive the CIO pin High with the on-chip pull-up (according to IODIS bit value). The pin can then be

an input (read in STATUS register).

Clear this bit to drive a low level on the CIO pin (according to IODIS bit value).

The reset value is 0.

AT83C24B bảng dữ liệu(PDF) 25 Page - ATMEL Corporation

AT83C24B bảng dữ liệu(HTML) 25 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

bảng dữ liệu tải về

Link URL