AT43USB326 datasheet(19/102 Pages) ATMEL

19 / 102 page

AT43USB326

3313D–USB–04/06

The most typical and general program setup for the Reset and Interrupt Vector Addresses are:

USB related interrupt events are routed to reset vectors 13 and 2 through a separate set of

interrupt, interrupt enable and interrupt mask registers that are mapped to the data SRAM

space. These interrupts must be enabled though their control register bits. In the event an

interrupt is generated, the source of the interrupt is identified by reading the interrupt registers.

The USB frame and transaction related interrupt events, such as Start of Frame interrupt, are

grouped in one set of registers: USB Interrupt Flag Register, USB Interrupt Enable Register

and USB Interrupt Mask Register. The USB Bus reset and suspend/resume are grouped in

another set of registers: Suspend/Resume Register, Suspend/Resume Interrupt Enable Reg-

ister and Suspend/Resume Interrupt Mask Register.

Address

Labels

Code

Comments

$000

jmp

RESET

; Reset Handler

$002

jmp

EXT_INT0

; IRQ0 Handler

$00E

jmp

TIM0_OVF

; Timer0

Overflow

Handler

$018

jmp

USB_HW

; USB Handler

;

$00d

MAIN:

ldi r16, high (RAMEND)

; Main Program

start

$00e

out SPH, r16

$00f

ldi r16, low (RAMEND)

$010

out SPL, r16

$011

<instr> xxx

...

AT43USB326 bảng dữ liệu(PDF) 19 Page - ATMEL Corporation

AT43USB326 bảng dữ liệu(HTML) 19 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL