AT43USB353M datasheet(20/95 Pages) ATMEL

20 / 95 page

AT43USB353M

3307B–USB–4/04

Watchdog Timer

Reset

When the watchdog times out, it will generate a short reset pulse of 1 XTAL cycle duration. On

the falling edge of this pulse, the delay timer starts counting the Time-out period t

TOUT.

Figure 8. Watchdog Reset During Operation

Non-USB Related

Interrupt Handling

The AT43USB353M has two non-USB 8-bit Interrupt Mask control registers; GIMSK (General

Interrupt Mask Register) and TIMSK (Timer/Counter Interrupt Mask Register).

When an interrupt occurs, the Global Interrupt Enable I-bit is cleared (zero) and all interrupts

are disabled. The user software can set (one) the I-bit to enable nested interrupts. The I-bit is

set (one) when a Return from Interrupt instruction, RETI, is executed.

For Interrupts triggered by events that can remain static (e.g. the Output Compare register1

matching the value of Timer/Counter1) the interrupt flag is set when the event occurs. If the

interrupt flag is cleared and the interrupt condition persists, the flag will not be set until the

event occurs the next time.

When the Program Counter is vectored to the actual interrupt vector in order to execute the

interrupt handling routine, hard-ware clears the corresponding flag that generated the inter-

rupt. Some of the interrupt flags can also be cleared by writing a logic one to the flag bit

position(s) to be cleared.

If an interrupt condition occurs when the corresponding interrupt enable bit is cleared (zero),

the interrupt flag will be set and remembered until the interrupt is enabled, or the flag is

cleared by software.

If one or more interrupt conditions occur when the global interrupt enable bit is cleared (zero),

the corresponding interrupt flag(s) will be set and remembered until the global interrupt enable

bit is set (one), and will be executed by order of priority.

Note that external level interrupt does not have a flag, and will only be remembered for as long

as the interrupt condition is active.

tTOUT

VCC

RESET

WDT

TIME-OUT

RESET

TIME-OUT

1 XTAL Cycle

INTERNAL

RESET

AT43USB353M bảng dữ liệu(PDF) 20 Page - ATMEL Corporation