STMPE811 datasheet(12/66 Pages) STMICROELECTRONICS

12 / 66 page

I2C interface

STMPE811

12/66

Doc ID 14489 Rev 5

4.1

I2C features

The features that are supported by the I2C interface are listed below:

●

I2C slave device

●

Operates at 1.8 V

●

Compliant to Philips I2C specification version 2.1

●

Supports standard (up to 100 Kbps) and fast (up to 400 Kbps) modes

Start condition

A Start condition is identified by a falling edge of SDATA while SCLK is stable at high state.

A Start condition must precede any data/command transfer. The device continuously

monitors for a Start condition and does not respond to any transaction unless one is

encountered.

Stop condition

A Stop condition is identified by a rising edge of SDATA while SCLK is stable at high state. A

Stop condition terminates communication between the slave device and the bus master. A

read command that is followed by NoAck can be followed by a Stop condition to force the

slave device into idle mode. When the slave device is in idle mode, it is ready to receive the

next I2C transaction. A Stop condition at the end of a write command stops the write

operation to registers.

Acknowledge bit

The acknowledge bit is used to indicate a successful byte transfer. The bus transmitter

releases the SDATA after sending eight bits of data. During the ninth bit, the receiver pulls

the SDATA low to acknowledge the receipt of the eight bits of data. The receiver may leave

the SDATA in high state if it does not acknowledge the receipt of the data.

STMPE811 bảng dữ liệu(PDF) 12 Page - STMicroelectronics