CS5155 datasheet(11/18 Pages) ONSEMI

11 / 18 page

CS5155

http://onsemi.com

condition ceases or the input voltage is pulled low. The

bottom FET and board trace must be properly designed to

implement the OVP function.

Figure 14. OVP Response to an Input−to−Output

Short Circuit by Immediately Providing 0% Duty

Cycle, Crow−Barring the Input Voltage to Ground

M 10.0 μs

Trace 1− Regulator Output Voltage (1.0 V/div.)

Trace 2− Inductor Switching Node 5.0 V/div.)

Trace 4− 5.0 V from PC Power Supply (5.0 V/div.)

Figure 15. OVP Response to an Input−to−Output Short

Circuit by Pulling the Input Voltage to Ground

M 5.00 ms

Trace 1− Regulator Output Voltage (1.0 V/div.)

Trace 4− 5.0 V from PC Power Supply (2.0 V/div.)

External Output Enable Circuit

On/off control of the regulator can be implemented

through the addition of two additional discrete components

(see Figure 16). This circuit operates by pulling the Soft

Start pin high, and the VFFB pin low, emulating a short

circuit condition.

Figure 16. Implementing Shutdown with the CS5155

Shutdown

Input

5.0 V

MMUN2111T1 (SOT−23)

8 V

FFB

IN4148

CS5155

External Power Good Circuit

An optional Power Good signal can be generated through

the use of four additional external components (see Figure

17). The threshold voltage of the Power Good signal can be

adjusted per the following equation:

VPower Good +

(R1 ) R2)

0.65 V

This circuit provides an open collector output that drives

the Power Good output to ground for regulator voltages less

than VPower Good.

Figure 17. Implementing Power Good with the CS5155

5.0 V

Power Good

10 k

VOUT

PN3904

6.2 k

PN3904

10 k

CS5155

CS5155 bảng dữ liệu(PDF) 11 Page - ON Semiconductor

CS5155 bảng dữ liệu(HTML) 11 Page - ON Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

bảng dữ liệu tải về

Link URL