DSP56367 datasheet(90/100 Pages) FREESCALE

90 / 100 page

PLL Performance Issues

DSP56367 Technical Data, Rev. 2.1

5-4

Freescale Semiconductor

One way to evaluate power consumption is to use a current per MIPS measurement methodology to

minimize specific board effects (i.e., to compensate for measured board current not caused by the DSP).

A benchmark power consumption test algorithm is listed in Appendix A, "Power Consumption

Benchmark". Use the test algorithm, specific test current measurements, and the following equation to

derive the current per MIPS value.

where:

ItypF2 = current at F2

ItypF1 = current at F1

= high frequency (any specified operating frequency)

= low frequency (any specified operating frequency lower than F2)

NOTE

F1 should be significantly less than F2. For example, F2 could be 66 MHz

and F1 could be 33 MHz. The degree of difference between F1 and F2

determines the amount of precision with which the current rating can be

determined for an application.

5.4

PLL Performance Issues

The following explanations should be considered as general observations on expected PLL behavior.

There is no testing that verifies these exact numbers. These observations were measured on a limited

number of parts and were not verified over the entire temperature and voltage ranges.

5.4.1

Input (EXTAL) Jitter Requirements

The allowed jitter on the frequency of EXTAL is 0.5%. If the rate of change of the frequency of EXTAL

is slow (i.e., it does not jump between the minimum and maximum values in one cycle) or the frequency

of the jitter is fast (i.e., it does not stay at an extreme value for a long time), then the allowed jitter can be

2%. The phase and frequency jitter performance results are only valid if the input jitter is less than the

prescribed values.

IMIPS

⁄

IMHz

⁄

typF2

typF1

–

() F2 F1

–

()

⁄

DSP56367 bảng dữ liệu(PDF) 90 Page - Freescale Semiconductor, Inc

DSP56367 bảng dữ liệu(HTML) 90 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100

bảng dữ liệu tải về

Link URL