ADG736L

Rev. 0 | Page 10 of 12

TERMINOLOGY

Ohmic resistance between D and S.

Flatness is defined as the difference between the maximum and

minimum value of on resistance as measured over the specified

analog signal range.

Source leakage current with the switch off.

Channel leakage current with the switch on.

Analog voltage on Terminal D and Terminal S.

Off switch source capacitance.

On switch capacitance.

Delay between applying the digital control input and the output

switching on (see Figure 13).

Delay between applying the digital control input and the output

switching off.

Off time or on time measured between the 90% points of both

switches, when switching from one address state to another (see

Figure 14).

Crosstalk

A measure of unwanted signal that is coupled through from one

channel to another as a result of parasitic capacitance.

Off Isolation

A measure of unwanted signal coupling through an off switch.

Bandwidth

The frequency at which the output is attenuated by −3 dB.

On Response

The frequency response of the on switch.

On Loss

The voltage drop across the on switch, seen on the On Response

vs. Frequency plot (see Figure 7) as how many decibels the

signal is away from 0 dB at very low frequencies.