ST72340 datasheet(149/191 Pages) STMICROELECTRONICS

149 / 191 page

ST72340, ST72344, ST72345

149/191

12.2 INSTRUCTION GROUPS

The ST7 family devices use an Instruction Set

consisting of 63 instructions. The instructions may

be subdivided into 13 main groups as illustrated in

the following table:

Using a prebyte

The instructions are described with 1 to 4 bytes.

In order to extend the number of available op-

codes for an 8-bit CPU (256 opcodes), three differ-

ent prebyte opcodes are defined. These prebytes

modify the meaning of the instruction they pre-

cede.

The whole instruction becomes:

PC-2 End of previous instruction

PC-1 Prebyte

Opcode

PC+1 Additional word (0 to 2) according to the

number of bytes required to compute the

effective address

These prebytes enable instruction in Y as well as

indirect addressing modes to be implemented.

They precede the opcode of the instruction in X or

the instruction using direct addressing mode. The

prebytes are:

PDY 90 Replace an X based instruction using

immediate, direct, indexed, or inherent

addressing mode by a Y one.

PIX 92

Replace an instruction using direct, di-

rect bit or direct relative addressing

mode to an instruction using the corre-

sponding indirect addressing mode.

It also changes an instruction using X

indexed addressing mode to an instruc-

tion using indirect X indexed addressing

mode.

PIY 91

Replace an instruction using X indirect

indexed addressing mode by a Y one.

12.2.1 Illegal Opcode Reset

In order to provide enhanced robustness to the de-

vice against unexpected behavior, a system of ille-

gal opcode detection is implemented. If a code to

be executed does not correspond to any opcode

or prebyte value, a reset is generated. This, com-

bined with the Watchdog, allows the detection and

recovery from an unexpected fault or interference.

Note: A valid prebyte associated with a valid op-

code forming an unauthorized combination does

not generate a reset.

Load and Transfer

CLR

Stack operation

PUSH

POP

RSP

Increment/Decrement

INC

DEC

Compare and Tests

TNZ

BCP

Logical operations

AND

XOR

CPL

NEG

Bit Operation

BSET

BRES

Conditional Bit Test and Branch

BTJT

BTJF

Arithmetic operations

ADC

ADD

SUB

SBC

MUL

Shift and Rotates

SLL

SRL

SRA

RLC

RRC

SWAP

SLA

Unconditional Jump or Call

JRA

JRT

JRF

CALL

CALLR

NOP

RET

Conditional Branch

JRxx

Interruption management

TRAP

WFI

HALT

IRET

Condition Code Flag modification

SIM

RIM

SCF

RCF

ST72340 bảng dữ liệu(PDF) 149 Page - STMicroelectronics

ST72340 bảng dữ liệu(HTML) 149 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL