Page 2

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE

© 2021 TELEDYNE RELAYS

Series RF131

SPDT Non-Latching

DC-12GHz, 20Gbps RF Relay

RF131\112021

GENERAL ELECTRICAL SPECIFICATIONS (-55 °C to 85 °C unless otherwise noted.)(Notes 2 & 3.)

Contact Arrangement

1 Form C (SPDT) with open contact grounded to case

Rated Duty

Continuous

Contact Load Rating

Resistive: .25A @ 28Vdc

Contact Life Rating

2,000,000 cycles typical @ low level

Coil Operating Power

315mW typical @ nominal rated voltage

Switching Time (inluding bounce)

10 ms. max. (5ms operate time, 2ms release time, 5ms contact bounce time)

Insulation Resistance

1,000MΩ min. between mutually isolated terminals

Dielectric Strength

350 V

rms (60Hz) @ Atmospheric Pressure

Propagation Delay

54-60 ps (typical)

DETAILED ELECTRICAL SPECIFICATIONS (-55 °C to 85 °C unless otherwise noted.) (Note 3)

BASE PART NUMBERS

RF131-5

RF131-12

Coil Voltage, Nominal (Vdc)

5.0

12.0

Coil Resistance (Ohms ±20%, 25°C)

80

460

Pick-up Voltage, Max (Vdc)

4.3

10.4

NOTES

1. Relay contacts will exhibit no chatter in excess of 10 µs or transfer in excess of 1 µs.

2. Characteristics shown as “typical” are based on available data and are best estimates. No ongoing verification tests are performed.

3. Unless otherwise specified, parameters are initial values.

4. Parts ordered with no suffix option will be provided with Gold-Plated leads which have a typical plating thickness of 25-40 µin.

5. The slash and characters appearing after the slash are not marked on the relay

6. Using an operate voltage less than the specified nominal coil voltage may result in unreliable operation.

7. Relay temperature during soldering shall not exceed 250°C, and reflow temperature shall not exceed 250°C, 3 passes, 1 minute each.

RF131

-

12

/

Q

Relay Series

Part Numbering System (Notes 4, 5, & 6)

Coil Voltage

5 = 5Vdc

12 = 12Vdc

Lead Finish

Q = Solder-Dipped Leads (Sn60/Pb40)

R = RoHS Compliant Solder (Sn99.3/Cu0.7)

No Suffix = Gold-Plated Leads

RF131