CS5467 datasheet(31/46 Pages) CIRRUS

31 / 46 page

CS5467

DS714A1

ADVANCE RELEASE

spikes from the power line. This event should not be confused with a DC overload

situation at the inputs, when the IOD (I2OD) and VOD (V2OD) bits will re-assert

themselves even after being cleared, multiple times.

LSD

Low Supply Detect. Set when the voltage at the PFMON pin falls below the low-voltage thresh-

old (PMLO), with respect to AGND pin. For a given part, PMLO can be as low as 2.3 V. LSD bit

cannot be permanently reset until the voltage at PFMON pin rises back above the high-voltage

threshold (PMHI), which is typically 100 mV above the device’s low-voltage threshold. PMHI will

never be greater than 2.7 V.

FUP

Epsilon Updated. Indicates an update to the epsilon value has been placed in the register.

Invalid Command. Normally logic 1. Set to logic 0 if the host interface is strobed with an 8-bit

word that is not recognized as one of the valid commands (see See Section 5.15 Commands

on page 24).

6.1.8 Peak Current (Ipeak, I2peak) and Peak Voltage (Vpeak, V2peak) Register

Address: 18 (Ipeak), 19 (Vpeak), 22 (I2peak), 23 (V2peak)

The Peak Current (Ipeak, I2peak) and Peak Voltage (Vpeak, V2peak) registers contain the instantaneous current

and voltage with the greatest magnitude detected during the last computation cycle. The value is represented

in two's complement notation and in the range of -1.0

≤ Ipeak,Vpeak < 1.0 (-1.0 ≤ I2peak,V2peak < 1.0), with the

binary point to the right of the MSB.

6.1.9 Apparent Power (S, S2) Register

Address: 20 (S), 24 (S2)

Apparent power S (S2) is the product of the VRMS and IRMS (V2RMS and I2RMS), The value is represented in

unsigned notation and in the range of 0

≤ S < 1.0 (0 ≤ S2 < 1.0), with the binary point to the right of the MSB.

6.1.10 Power Factor (PF, PF2) Register

Address: 21 (PF), 25 (PF2)

Power Factor is calculated by dividing the Active (Real) Power by Apparent Power. The value is represented in

two's complement notation and in the range of -1.0

≤ PF < 1.0 (-1.0 ≤ PF2 < 1.0), with the binary point to the

right of the MSB.

MSB

LSB

-(20)2-1

2-2

2-3

2-4

2-5

2-6

2-7

.....

2-17

2-18

2-19

2-20

2-21

2-22

2-23

MSB

LSB

-(20)2-1

2-2

2-3

2-4

2-5

2-6

2-7

.....

2-17

2-18

2-19

2-20

2-21

2-22

2-23

MSB

LSB

-(20)2-1

2-2

2-3

2-4

2-5

2-6

2-7

.....

2-17

2-18

2-19

2-20

2-21

2-22

2-23

CS5467 bảng dữ liệu(PDF) 31 Page - Cirrus Logic

CS5467 bảng dữ liệu(HTML) 31 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

bảng dữ liệu tải về

Link URL