ADP3186 datasheet(23/24 Pages) AD

23 / 24 page

ADP3186

Rev. A | Page 23 of 24

Power Circuitry Recommendations

The switching power path should be routed on the PCB to

encompass the shortest possible length to minimize radiated

switching noise energy (EMI) and conduction losses in the

board. Failure to take proper precautions often results in EMI

problems for the entire PC system as well as noise-related

operational problems in the power converter control circuitry.

The switching power path is the loop formed by the current

path through the input capacitors and the power MOSFETs

including all interconnecting PCB traces and planes. Using

short and wide interconnection traces is especially critical in

this path for two reasons: it minimizes the inductance in the

switching loop, which can cause high energy ringing, and it

accommodates the high current demand with minimal

voltage loss.

Whenever a power dissipating component, for example, a

power MOSFET, is soldered to a PCB, the liberal use of vias,

both directly on the mounting pad and immediately surround-

ing it, is recommended. Two important reasons for this are

improved current rating through the vias and improved thermal

performance from vias extended to the opposite side of the

PCB, where a plane can more readily transfer the heat to the air.

Make a mirror image of any pad being used to heat sink the

MOSFETs on the opposite side of the PCB to achieve the best

thermal dissipation to the air around the board. To further

improve thermal performance, use the largest possible pad area.

The output power path should also be routed to encompass a

short distance. The output power path is formed by the current

path through the inductor, the output capacitors, and the load.

For best EMI containment, a solid power ground plane should

be used as one of the inner layers extending fully under all the

power components.

Signal Circuitry Recommendations

The output voltage is sensed and regulated between the FB pin

and the FBRTN pin, which connect to the signal ground at the

load. To avoid differential mode noise pickup in the sensed

signal, the loop area should be small. Therefore, the FB and

FBRTN traces should be routed adjacent to each other on top of

the power ground plane back to the controller.

The feedback traces from the switch nodes should be connected

as close as possible to the inductor. The CSREF signal should be

connected to the output voltage at the nearest inductor to the

controller.

ADP3186 bảng dữ liệu(PDF) 23 Page - Analog Devices

ADP3186 bảng dữ liệu(HTML) 23 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

bảng dữ liệu tải về

Link URL