MC68340 datasheet(286/441 Pages) FREESCALE

286 / 441 page

6- 36

MC68340 USER’S MANUAL

MOTOROLA

For normal transfers aligned with the size and address, only two bus cycles are required

for each transfer: a read from the source and a write to the destination.

6.9 DMA CHANNEL INITIALIZATION SEQUENCE

The following paragraphs describe DMA channel initialization and operation. If the DMA

capability of the MC68340 is being used, the initialization steps should be performed

during the part initialization sequence. The mode operation steps should be performed to

start a DMA transfer. The

DONE

≈ pin requires an external pullup resistor even if operating

only in the internal request mode.

6.9.1 DMA Channel Configuration

The following steps can be accomplished in any order when initializing the DMA channel.

These steps need to be performed for each channel used.

Module Configuration Register (MCR)

• Clear the stop bit (STP) for normal operation. (Only one STP bit exists for both

channels.)

• Select whether to respond to or ignore FREEZE (FRZx bits). (Only one set of FRZx

bits exits for both channels.)

• If desired, enable the external data bus operation in single-address mode (SE bit).

• Program the interrupt service mask to set the level below which interrupts are ignored

during a DMA transfer (ISM bits). The channel will begin operation when the level of

the CPU32 SR I2-I0 bits is less than or equal to the level of the DMA ISM bits.

• Select the access privilege for the supervisor/user registers (SUPV bit).

• Program the master arbitration ID (MAID) to establish priority on the IMB between

both DMA channels. Note that the two DMA channels should have distinct MAIDs if

both channels are being used. (If they are programmed the same, channel 1 has

priority.)

• Select the interrupt arbitration level for the DMA channel (IARB bits). (Only one set of

IARB bits exits for both channels.)

Interrupt Register (INTR)

• Program the interrupt priority level for the channel interrupt (INTL bits).

• Program the vector number for the channel interrupt (INTV bits).

Channel Control Register (CCR)

• If desired, enable the interrupt when breakpoint is recognized and the channel is the

bus master (INTB bit).

• If desired, enable the interrupt when done without an error condition (INTN bit).

• If desired, enable the interrupt when the channel encounters an error (INTE bit).

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68340 bảng dữ liệu(PDF) 286 Page - Freescale Semiconductor, Inc

MC68340 bảng dữ liệu(HTML) 286 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL