MC68340 datasheet(270/441 Pages) FREESCALE

270 / 441 page

6- 20

MC68340 USER’S MANUAL

MOTOROLA

Each operand transfer in dual-address mode requires from two to five bus cycles in

response to each operand transfer request. If the source and destination operands are the

same size, two cycles will transfer the complete operand. If the source and destination

operands are different sizes, the number of cycles will vary. If the source is a long-word

and the destination is a byte, there would be one bus cycle for the read and four bus

cycles for the write. Once the DMA channel has started a dual-address operand transfer, it

must complete that transfer before releasing ownership of the bus or servicing a request

for another channel of equal or higher priority, unless one of the bus cycles is terminated

with a bus error during the transfer.

6.6.3 Channel Termination

The channel can terminate by normal completion or from an error. The status of a DMA

operation can be determined by reading the CSR. The DMA channel can also interrupt the

processor to inform it of errors, normal transfer completion, or breakpoints. The fast

termination option can also be used to provide a two-clock access for external requests.

6.6.3.1 CHANNEL TERMINATION. The channel operation can be terminated for several

reasons: the BTC is decremented to zero, a peripheral device asserts

DONE

≈ during an

operand transfer, the STR bit is cleared in the CCR, a bus cycle is terminated with a bus

error, or a reset occurs.

6.6.3.2 INTERRUPT OPERATION. Interrupts can be generated by error termination of a

bus cycle or by normal channel completion. Specifically, if the CCR interrupt error (INTE)

bit is set and a bus error on source (CCR BES) bit, bus error on destination (CCR BED)

bit, or configuration error (CCR CONF) bit is set, the CCR IRQ bit is set. In this case,

clearing the INTE, BES, BED, or CONF bits causes the IRQ bit to be cleared. If the

interrupt normal (CCR INTN) bit is set and the CCR DONE bit is set, the IRQ bit is set. In

this case, clearing the INTN or the DONE bit causes the IRQ bit to be cleared. If the

interrupt breakpoint (CCR INTB) and the CSR BRKP bits are set, the IRQ bit is set.

Clearing INTB or BRKP clears IRQ.

6.6.3.3 FAST TERMINATION OPTION. Using the system integration module (SIM40) chip

select logic, the fast termination option (Figure 6-13) can be employed to give a fast bus

access of two clock cycles rather than the standard three-cycle access time for external

requests. The fast termination option is described in Section 3 Bus Operation and

Section 4 System Integration Module.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68340 bảng dữ liệu(PDF) 270 Page - Freescale Semiconductor, Inc