PicoScope® 4000A Series

Split-screen display

The PicoScope 6 software can display up to 16 scope and spectrum

views at once, making comparisons and analysis even clearer. The

split-screen display can be customized to show whichever combination

of waveforms you need, to display multiple channels or different

variants of the same signal. Additionally, each waveform shown works

with individual zoom, pan, and filter settings for ultimate flexibility.

Alongside the facility to use monitors many times larger than a fixed

scope display, these are further reasons to choose a USB oscilloscope

over a traditional benchtop model.

Complex embedded systems

When debugging an embedded system with a scope, you can quickly run out of channels.

You may need to look at an I2C or SPI bus at the same time as multiple power rails, DAC

outputs and logic signals. With up to eight channels, the PicoScope 4000A Series can

cope with all of this. Choose whether to decode up to eight serial buses, with analog

waveforms and decoded data both visible, or a combination of serial buses and other

analog or digital signals. PicoScope provides advanced triggering on all channels, so you

can search for runt pulses, dropouts and noise as well as looking for data patterns using

the 4-input Boolean logic trigger.

DeepMeasure™

One waveform, millions of measurements.

Measurement of waveform pulses and cycles is key to verification of the performance

of electrical and electronic devices. DeepMeasure delivers automatic measurements

of important waveform parameters, such as pulse width, rise time and voltage. Up to a

million cycles can be displayed with each triggered acquisition. Results can be easily

sorted, analyzed and correlated with the waveform display.