7

DATASHEET // RUTX09

1. To enter the router's Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.

2. Use login information shown in image A when prompted for authentication.

3. After you log in, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters,

including at least one uppercase letter, one lowercase letter, and one digit. This step is mandatory, and

you will not be able to interact with

the router's WebUI before you change the password.

4. When you change the router's password, the Configuration Wizard will start. The Configuration Wizard is a tool used to set up some of the

router's main operating parameters.

5. Go to the Overview page and pay attention to the Signal Strength indication (image B). To maximize the cellular performance try adjusting

the antennas or changing the location of your device to achieve the best signal conditions.

LOGIN TO DEVICE

1. Pull out the SIM needle from the front panel of the router.

2. Push the SIM holder button with the SIM needle.

3. Pull out the SIM holder.

4. Insert your SIM card into the SIM holder.

5. Slide the SIM holder back into the router.

6. Attach all antennas.

7. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.

8. Connect to the device via an Ethernet cable connected to LAN port.

HARDWARE INSTALLATION

A.

B.

admin

admin01

Bytes received/sent*

SIM card slot in use

Data connection state

State

*Order code dependent.

**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.

Bundled accessories specifications*

Radio specifications

RF technologies

Max RF power

3G, 4G, GNSS

24 dBm@WCDMA, 23 dBm@LTE

Mobile antenna

698~960/1710~2690 MHz, 50 Ω, VSWR<3, gain** 3 dBi, omnidirectional, SMA male connector

GNSS antenna

1575.42~1602 MHz, 2.2~5 VDC, VSWR<1.5, active total gain** 28 dB (typ.), RHCP polarization, SMA male connector

Power adapter

Input: 0.6A@100-240VAC, Output: 12VDC, 1.5A, 4-pin plug

TECHNICAL INFORMATION

-65 dBm

Connected

Registered (home); OPERATOR; 4G (LTE)

Ready

348.7 KB / 223.5 KB

Copyright © 2022, TELTONIKA NETWORKS. Specifications and information given in this document are subject to change by TELTONIKA NETWORKS without prior notice.