ICS8432-51 datasheet(10/22 Pages) RENESAS

10 / 22 page

IDT™ / ICS™ 3.3V LVPECL FREQUENCY SYNTHESIZER

ICS8432CY-51 REVISION F NOVEMBER 13, 2012

ICS8432-51

700MHZ, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER

CC - 2V

RTT

o = 50Ω

FOUT

FIN

RTT =

((V

OH + VOL) / (VCC – 2)) – 2

3.3V

125

o = 50Ω

FOUT

FIN

The clock layout topology shown below is a typical termination

for LVPECL outputs. The two different layouts mentioned are

recommended only as guidelines.

FOUTx and nFOUTx are low impedance follower outputs that

generate ECL/LVPECL compatible outputs. Therefore, termi-

nating resistors (DC current path to ground) or current sources

must be used for functionality. These outputs are designed to

FIGURE 5B. LVPECL OUTPUT TERMINATION

FIGURE 5A. LVPECL OUTPUT TERMINATION

drive 50

Ω transmission lines. Matched impedance techniques

should be used to maximize operating frequency and minimize

signal distortion. Figures 5A and 5B show two different layouts

which are recommended only as guidelines. Other suitable clock

layouts may exist and it would be recommended that the board

designers simulate to guarantee compatibility across all printed

circuit and clock component process variations.

TERMINATION FOR LVPECL OUTPUTS

INPUTS:

CRYSTAL INPUTS

For applications not requiring the use of the crystal oscillator input,

both XTAL_IN and XTAL_OUT can be left floating. Though not

required, but for additional protection, a 1k

Ω resistor can be tied

from XTAL_IN to ground.

REF_CLK INPUT

For applications not requiring the use of the test clock, it can be

left floating. Though not required, but for additional protection, a

Ω resistor can be tied from the REF_CLK to ground.

LVCMOS CONTROL PINS

All control pins have internal pull-ups or pull-downs; additional

resistance is not required but can be added for additional

protection. A 1k

Ω resistor can be used.

RECOMMENDATIONS FOR UNUSED INPUT AND OUTPUT PINS

OUTPUTS:

LVPECL OUTPUTS

All unused LVPECL outputs can be left floating. We recommend

that there is no trace attached. Both sides of the differential output

pair should either be left floating or terminated.

ICS8432-51 bảng dữ liệu(PDF) 10 Page - Renesas Technology Corp

ICS8432-51 bảng dữ liệu(HTML) 10 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

bảng dữ liệu tải về

Link URL