| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
PAC1944T-E/J6CX. bảng dữ liệu(PDF) 59 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
PAC1944T-E/J6CX. bảng dữ liệu(HTML) 59 Page - Microchip Technology |
|
59 / 96 page ![]() 2021 Microchip Technology Inc. DS20006543A-page 59 PAC194X bit 7-4 CHANNEL_N_OFF[3:0]: Allow one or more channels to be inactive during the conversion cycle. These settings apply for normal continuous round robin conversion cycles or Single-Shot mode, if Single-Shot mode is selected. If a channel is set to inactive, the auto-incrementing address pointer will skip addresses associated with that channel unless the pointer skipping bit 1 in this register is set. In PAC194X devices, deactivating channels allows faster sampling. Burst or Fast modes are selected using bits [15:12] in this register. PAC1944-1 default = 0b0000 (register default 0700h) (shown above) PAC1943-1 default = 0b0001 (register value 0710h) PAC1942-1 default = 0b0011 (register value 0730h) PAC1942-2 default = 0b0011 (register value 0730h) PAC1941-1 default = 0b0111 (register value 0770h) PAC1941-2 default = 0b0111 (register value 0770h) bit 3-0 Unimplemented, read as ‘0’. REGISTER 7-18: NEG_PWR_FSR _LAT (24H) REGISTER R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 CFG_VS1[1:0] CFG_VS2[1:0] CFG_VS3[1:0] CFG_VS4[1:0] bit 15 bit 8 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 CFG_VB1[1:0] CFG_VB2[1:0] CFG_VB3[1:0] CFG_VB4[1:0] bit 7 bit 0 Legend: R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’ -n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown This register holds an image of Register 7-11. The bits in this register reflect the settings that were active before the most recent REFRESH command (including REFRESH_V and/or REFRESH_G). The values in register 1Dh may be programmed but not activated by one of the REFRESH commands. This register shows the settings that were active prior to the most recent REFRESH command and therefore correspond to the dataset that is held in the readable reg- isters. This register is valid when the results registers are valid, 1 ms after a REFRESH/_V/_G command. bit 15-14 CFG_VS1[1:0]: Configure Channel 1 FSR for VSENSE measurements 00 = Channel 1 VSENSE has unipolar +100 mV to 0V FSR (default) 01 = Channel 1 VSENSE has bipolar +100 mV to -100 mV FSR 10 = Channel 1 VSENSE has bipolar +50 mV to -50 mV FSR 11 = Reserved bit 13-12 CFG_VS2[1:0]: Configure Channel 2 FSR for VSENSE measurements 00 = Channel 2 VSENSE has unipolar +100 mV to 0V FSR (default) 01 = Channel 2 VSENSE has bipolar +100 mV to -100 mV FSR 10 = Channel 2 VSENSE has bipolar +50 mV to -50 mV FSR 11 = Reserved bit 11-10 CFG_VS3[1:0]: Configure Channel 3 FSR for VSENSE measurements 00 = Channel 3 VSENSE has unipolar +100 mV to 0V FSR (default) 01 = Channel 3 VSENSE has bipolar +100 mV to -100 mV FSR 10 = Channel 3 VSENSE has bipolar +50 mV to -50 mV FSR 11 = Reserved REGISTER 7-17: CTRL_LAT (23H) REGISTER (CONTINUED) |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |