Moujen Electric Co., Ltd. (Taiwan HQ) - Since 1961

110

moujenglobal.com

Mounting and Tightening

• Please view each individual product page’s allowed parameters for details.

• Please follow these parameters diligently. Otherwise products may not function properly.

Wiring & Cabling

• Use M3.5-nylon insulation covered crimp terminals (round type)

• Appropriate wire size is AWG18.

• Do not supply electric power when wiring. Otherwise electric shock may result.

• Do not pull on the wires with excessive force.

• Avoid connecting the wires directly to the terminal. Instead, attach using a crimp terminal.

• Grounding is only installed on models with ground terminals.

• In the case of prewired connector and direct connector: Holding the connector certainly when pulling connector. Do

not pull the cable with excessive force.

Conduit Installation

• The connector must be tightened at a suitable tightening torque. Tightening with excessive torque could damage the

case.

• Select the connector based on the sealed rubber inner diameter for matching the cable outer diameter.

• When mounting the connector, use seal tape (not needed if the connector includes an O-ring) on the threaded

section of the connector to ensure sealing performance.

• To ensure compliance of this Switch with the CSA standards, use of a waterproof connector compliant to CSA

regulations.

• Using an inappropriate connector or assembling Switches incorrectly (assembly, tightening torque) can result in

malfunction, leakage current, or fire. Be sure to read the connector instruction manual thoroughly beforehand.

• Even when the connector is assembled and set correctly, ends of the cable inside the Switch may come in contact.

This can lead to malfunction, leakage current, or fire. Thus, be sure to protect the end of the cable from splashes of oil

or water and corrosive gases.

• The following wiring is recommended for preventing the entry of fluids from the conduit opening.

No envelopment of cable jacket in

conduit. Exposed single wires.

Partial/loose envelopment of cable

jacket in conduit

Full envelopment of cable jacket in

conduit.

❌Incorrect

❌Incorrect

Correct

Actuating Terminology