5

Dimensions shown in: mm

Specifications and dimensions subject to change

www.ckswitches.com

PROCESS – RETENTION TEST

Use Retention Test Tool - P/N C115373-0003

This tool is equipped with 2 test tips at the ends for use with Pin and Socket connectors.

It is delivered with:

• 2 protective caps

• 1 adaptator for connectors MDMA-51S

1 calibration certificate referring to applicable force and travel

If necessary, we can perform the calibration of tools already in service.

Use P/N C115373-0003 CA for a quote.

MDMB Connector with Pin Contacts:

Insert the tip of the tool around the Pin contact

Push the tool up to the stop with the front face of the connector

Pull back lightly on wire to be sure contact is locked securely

MDMB Connector with Socket Contacts:

Insert the tip of the tool inside the Socket contact

Push the tool up to the stop with the front face of the connector

Pull back lightly on wire to be sure contact is locked securely