TMUX7436FPWR datasheet(26/50 Pages) TI

26 / 50 page

7.3 On-Leakage Current

Source on-leakage current (IS(ON)) and drain on-leakage current (ID(ON)) denote the channel leakage currents

when the switch is in the on state. IS(ON) is measured with the drain floating, while ID(ON) is measured with the

source floating. Figure 7-3 shows the circuit used for measuring the on-leakage currents.

S1A

GND

Is (ON)

S1B

VDD

VSS

IS(ON)

S1A

GND

S1B

VDD

VSS

ID(ON)

ID (ON)

N.C.

S2A

Is (ON)

S2B

N.C.

S2A

S2B

N.C.

Figure 7-3. On-Leakage Measurement Setup

7.4 Input and Output Leakage Current Under Overvoltage Fault

If any of the source pin voltage goes above the supplies (VDD or VSS) by one threshold voltage (VT), then the

overvoltage protection feature of the TMUX7436F is triggered to turn off the switch under fault, keeping the

fault channel in a high-impedance state. IS(FA) and ID(FA) denotes the input and output leakage current under

overvoltage fault conditions, respectively. When the overvoltage fault occurs, the supply (or supplies) can either

be in normal operating condition (Figure 7-4) or abnormal operating condition (Figure 7-5). During abnormal

operating condition, the supply (or supplies) can either be unpowered (VDD= VSS = 0 V) or floating (VDD= VSS =

no connection), and remains within the leakage performance specifications.

S1A

GND

IS (FA)

S1B

VDD

VSS

S2A

IS (FA)

S2B

ID (FA)

N.C.

IS(FA) / ID(FA)

( |VS| > |VDD + VT| or |VSS - VT| )

Figure 7-4. Measurement Setup for Input and Output Leakage Current under Overvoltage Fault With

Normal Supplies

TMUX7436F

SCDS459A – OCTOBER 2022 – REVISED NOVEMBER 2022

www.ti.com

Submit Document Feedback

Product Folder Links: TMUX7436F

TMUX7436FPWR bảng dữ liệu(PDF) 26 Page - Texas Instruments

TMUX7436FPWR bảng dữ liệu(HTML) 26 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

bảng dữ liệu tải về

Link URL