| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
RNS2DBD100R bảng dữ liệu(PDF) 2 Page - Stackpole Electronics, Inc. |
|
|
|||||||||||||||||||||||||||||
RNS2DBD100R bảng dữ liệu(HTML) 2 Page - Stackpole Electronics, Inc. |
|
2 / 5 page ![]() Rev Date: 10/22/2020 2 www.seielect.com This specification may be changed at any time without prior notice. marketing@seielect.com Please confirm technical specifications before you order and/or use. RNS Series Ultra Miniature Metal Film Resistor Stackpole Electronics, Inc. Resistive Product Solutions Performance Characteristics (cont.) Item Performance Test Method Change of Resistance ≤ ± (1% + 0.05 Ω) Tensile: Tensile strength: 10 N Bend: Change of Resistance ≤ ± (0.2% + 0.05 Ω) Bending strength: 5 N Change of Resistance ≤ ± (0.3% + 0.05 Ω) Change of Resistance ≤ ± (1% + 0.05 Ω) Change of Resistance ≤ ± (0.5% + 0.05 Ω) Change of Resistance ≤ ± (3% + 0.05 Ω) Change of Resistance ≤ ± (3% + 0.05 Ω) Operating temperature range is -55°C to +155°C Damp Heat, Steady State In the chamber having temp. 40 ± 2ºC and relative humidity 93 ± 3%, apply one percent of the rated power, 1.5 hour ON, 0.5 hour OFF for 1000 hours and leave in room temperature for one hour after test. Endurance at 70ºC At 70 ± 2ºC, apply rated DC voltage 1.5 hour ON, 0.5 hour OFF for 1000 hours and leave in room temperature for one hour after test. Solderability More than 95% of the surface of the lead shall be covered by new solder. Dip the lead into a solder bath having a temperature of 245 ± 5ºC up to 1.5 ± 0.5 mm from the body of the resistors and hold it form 5 ± 0.5 seconds. Rapid Change of Temperature The resistor shall be subjected to 5 continuous cycles, each as show in the table below: Vibration Apply 1.5 mm amplitude vibration to three directions perpendicular to each other 2 hours each, total 6 hours. Vibrating frequency is 10 Hz - 55 Hz - 10 Hz cycle in 1 minute sweeping and repeat cycle. Resistance to Soldering Heat Dip the lead into a solder bath having a temperature of 260ºC ± 5ºC up to 1.5 ± 0.5 mm from the body of the resistors and hold it for 10 ± 0.5 seconds and leave in room temperature for one hour after test. Solvent Resistance There shall be no damage on the insulating surface. Soak in a Isopropyl alcohol for 5 minutes. After drying up for 5 minutes, stress of 5 N is added with absorbent cotton and it does by five round trips at the rate of one round trip a second. Overload (Short Time) Apply 2.5 times rated voltage or max. overload voltage whichever is lower for 5 seconds and leave in room temperature for one hour after test. Robustness of Termination The body of the resistor is fixed, a static load is added in the direction of drawing out of the terminal, and it maintains it for 10 ± 1 seconds. Component body shall be fixed so that terminals are perpendicular to the floor. A static load specified below shall be applied to the terminal acting in a direction away from the body. The body of piezoelectric oscillator shall then be inclined through an angle of 90º in the vertical plane and then returned to its initial position in 2 or 3 seconds then the body shall be inclined to the reversed direction through an angle 90º and then returned to its initial position in 2 or 3 seconds. Temperature Duration 1 Minimum Operating Temperature 30 min. 2 Standard Atmospheric Condition ≤ 30 sec. 3 Max Operating Temperature 30 min. 4 Standard Atmospheric Condition ≤ 30 sec. |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |