LS-T3 datasheet(31/64 Pages) IDEC

31 / 64 page

Instructions

Contact Bounce

When the button is reset by pulling or turning, the NC main

contacts will bounce. When pressing the button, the NO

monitor contacts will bounce.

When designing a control circuit, take the contact bounce

time into consideration (reference value: 20 ms).

LED Illuminated Switches

An LED lamp is built into the contact block and cannot be

replaced.

Installing the Anti-rotation Ring

HW9Z-RL

Align the side without thread on the operator with TOP

marking, the small ▲ marking on the anti-rotation ring, and

the recess on the mounting panel.

TOP Marking

▲

marking on the anti-rotation ring

Without thread

Anti-rotation Ring (HW9Z-RL)

Installing the Nameplate

Align the side without thread on the operator with TOP

marking, the projection on the nameplate, and the recess

on the mounting panel.

Nameplate or Switch Guard

When anti-rotation is not required, remove the projection

from the nameplate or switch guard using pliers.

Switch Guard

Projections

Nameplate

Handling

Do not expose the switch to excessive shocks and vibra-

tions, otherwise the switch may be deformed or damaged,

causing malfunction or operation failure.

XW Series Emergency Stop Switches ø22

LS-T3 bảng dữ liệu(PDF) 31 Page - IDEC Corporation