B7-4

PIN

ADAPTOR

0.425 (10.80)

0.218 (5.54)

0.125 (3.18)

± 0.010 (0.25)

0.180

(4.57)

0.063 (1.60)

DIA.

R 0.100 (2.54)

0.468 (11.89)

0.040 (1.02) DIA.

0.045 (1.14) DIA.

To prevent unwanted solder reflow, Interpoint suggests the use of SN 96 (high-temp solder) to connect the

PIN to the converter terminal and SN 62 to connect the PIN to the board. The soldering restrictions referenced

on the data sheets of the listed Interpoint products are 300°C for a maximum of 10 seconds per terminal.

PIN adaptors are designed to be used with case U1 (see Section B8).

Nominal dimensions in inches (mm)

Tolerance: ±0.005 (±0.13) for three decimal places, ±0.01 (±0.3) for two decimal places.

91113-001-DTS Rev A

DQ# 5022

All technical information is believed to be accurate, but no responsibility is

assumed for errors or omissions. Interpoint reserves the right to make changes in

products or specifications without notice. Copyright © 1996 - 1999 Interpoint. All

rights reserved.