LSM6DSRX datasheet(32/171 Pages) STMICROELECTRONICS

32 / 171 page

•

the chain for OIS/EIS where the ODR is at 6.66 kHz and the LPF1 is available. The LPF1 configuration

depends on the setting of the FTYPE_[1:0] _OIS bit in register CTRL2_OIS (71h); for more details about the

filter characteristics see Table 160. Gyroscope OIS chain digital LPF1 filter bandwidth selection. Gyroscope

output values are in registers 22h to 27h with the selected full scale (FS[1:0]_G_OIS bit in CTRL1_OIS

(70h)).

6.5

OIS

This paragraph describes OIS functionality and the dedicated accelerometer-gyroscope DSP chain.

There is a dedicated gyroscope and accelerometer DSP for OIS.

Other features can be configured:

•

Self-test on OIS side

•

DEN on OIS side

The camera module is completely independent from the application processor as shown in Figure 22.

The Auxiliary SPI can configure OIS functionality through INT_OIS (6Fh), CTRL1_OIS (70h), CTRL2_OIS (71h),

CTRL3_OIS (72h).

Reading from the Auxiliary SPI is enabled only when the OIS_EN_SPI2 bit in the CTRL1_OIS (70h) register is set

to '1'. This bit also turns on the gyroscope OIS chain.

The Primary Interface can access the OIS control registers (INT_OIS (6Fh), CTRL1_OIS (70h), CTRL2_OIS

(71h), CTRL3_OIS (72h)) in read mode.

Figure 22. Auxiliary SPI full control (a) and enabling primary interface (b)

UI/OIS

I3C/SPI/I2C

Camera Module

OIS Driver

Image

Sensor

Actuator

SPI_Aux

UI/OIS

I3C/SPI/I2C

Camera Module

OIS Driver

Image

Sensor

Actuator

SPI_Aux

(a)

(b)

LSM6DSRX

OIS

DS13007 - Rev 3

page 32/171

LSM6DSRX bảng dữ liệu(PDF) 32 Page - STMicroelectronics

LSM6DSRX bảng dữ liệu(HTML) 32 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL