WD1 datasheet(10/23 Pages) ETC

10 / 23 page

10-18

WD 1 (M) / WD 1000 (M)

7.1

Selecting Menu 1 special functions

Special functions

Navigation

STANDBY

EXIT

III

SETBACK

AUTO OFF

OFFSET

WINDOW

°C / °F

1. Press and hold down the UP and DOWN buttons simultaneously.

"– 1 –“ appears in the display after 2 s.

2. Release the buttons.

Selection of the special functions of Menu 1 is activated.

The settings can now be made.

- Press the I, II buttons to select menu items.

- Press the III button to exit the menu again (EXIT).

Resetting the special functions to the factory settings

1. Press and hold down button III.

2. Then press the UP and DOWN buttons simultaneously.

"FSE“ appears in the display.

The soldering station is now reset to the factory settings.

Setting the standby temperature

The standby temperature is automatically set after a temperature

deactivation. The actual temperature flashes in the display.

"STANDBY" appears on the display

(100 °C – 300 °C / 200 °F – 600 °F).

1. Select the menu item STANDBY in Menu 1.

2. Set the setpoint value for the standby temperature with the UP or

DOWN button.

3. Press the I (back) or II (forwards) button to switch to the next

menu item.

III

WD1 bảng dữ liệu(PDF) 10 Page - List of Unclassifed Manufacturers