LM324ADE4 datasheet(16/47 Pages) TI

16 / 47 page

8.3 Feature Description

8.3.1 Unity-Gain Bandwidth

Gain bandwidth product is found by multiplying the measured bandwidth of an amplifier by the gain at which that

bandwidth was measured. These devices have a high gain bandwidth of 1.2 MHz.

8.3.2 Slew Rate

The slew rate is the rate at which an operational amplifier can change its output when there is a change on the

input. These devices have a 0.5-V/μs slew rate.

8.3.3 Input Common Mode Range

The valid common mode range is from device ground to VCC – 1.5 V (VCC – 2 V across temperature). Inputs

may exceed VCC up to the maximum VCC without device damage. At least one input must be in the valid input

common mode range for output to be correct phase. If both inputs exceed valid range then output phase is

undefined. If either input is less than –0.3 V then input current should be limited to 1 mA and output phase is

undefined.

8.4 Device Functional Modes

These devices are powered on when the supply is connected. This device can be operated as a single supply

operational amplifier or dual supply amplifier depending on the application.

LM124, LM124A, LM224, LM224A, LM224K, LM224KA

LM324, LM324A, LM324B, LM324K, LM324KA

LM2902, LM2902B, LM2902K, LM2902KV, LM2902KAV

SLOS066X – SEPTEMBER 1975 – REVISED MAY 2022

www.ti.com

Submit Document Feedback

Product Folder Links: LM124 LM124A LM224 LM224A LM224K LM224KA LM324 LM324A LM324B LM324K

LM324KA LM2902 LM2902B LM2902K LM2902KV LM2902KAV

LM324ADE4 bảng dữ liệu(PDF) 16 Page - Texas Instruments