PEM® TY-D® self-clinching tie-mounts provide secure metal attachment points for mounting wires to electronic chassis

or enclosures. TY-D® hardware can be a great improvement over traditional mounting methods. They can be placed with

assurance at designed locations and angles to remain secure for the life of the assembly.

Fastener drawings and

models are available at

www.pemnet.com

SELF-CLINCHING TY-D® CABLE TIE-MOUNTS

Depending on placement of the

fastener within the mounting hole, on

the reverse side of the sheet, a slight

gap may be noticeable along the non-

clinching edges of the fastener after

installation. If gap is not acceptable

in your application, check with

The mounting hole is defined by two

dimensions. The two thick lines shown must

be straight for the entire length defined

by “Side 2” and must be separated by the

distance shown as “Side 1” (Side 1 and Side 2

are the two dimensions given for the mounting

hole on pages 3 and 4). The illustration shows

three examples (#1, #2, and #3) of how it can

be achieved. Example #4 in the lower right

side will not work.

MOUNTING HOLE EXAMPLES

Side 2

Side 1

#1

Side 2

Side 1

#2

Side 2

Side 1

#3

Side 2

Side 1

#4

Mounting Hole Examples

All PEM® products meet our stringent quality standards. If you require additional industry or other specific quality certifications, special procedures and/or part

numbers are required. Please contact your local sales office or representative for further information.

Regulatory compliance information is available in Technical Support section of our website. Specifications subject to change without notice. See our website for the

most current version of this bulletin.

© 2022 PennEngineering.