F0109 Datasheet

R35DS0035EU0103 Rev.1.03

Jan 13, 2022

Page 13

6.

Application Information

The F0109 has been optimized for use in high performance RF applications ranging from 0.65GHz to 1GHz.

6.1

Power Supplies

to minimize noise and fast transients. Supply noise can degrade noise figure and fast transients can trigger ESD

clamps and cause them to fail. Supply voltage change, or transients should have a slew rate smaller than

1V/20µs. In addition, keep all control pins at 0V (±0.3V) while the supply voltage ramps or while it returns to zero.

6.2

Startup Condition

At device power-up, both channels default to the power state as determined by the logic present on the STBY1

and STBY2 pins.

7.

Package Outline Drawings

The package outline drawings are located at the end of this document and are accessible from the Renesas

website (see package links in Ordering Information). The package information is the most current data available

and is subject to change without revision of this document.

8.

Ordering Information

Part Number

Package Description

MSL Rating

Carrier type

Temp. Range

F0109NBTI

4 × 4 × 0.75 mm 16-VFQFPN

1

Tray

-40° to +105°C

F0109NBTI8

4 × 4 × 0.75 mm 16-VFQFPN

1

Tape and Reel

-40° to +105°C

F0109EVB

Evaluation Board

Table 3. Pin1 Orientation in Tape and Reel Packaging

Part Number Suffix

Pin 1 Orientation

Illustration

BTI8

Quadrant 1 (EIA-481-C)