Instruction Sheet

I

Mini Mate

STS-N-001

IPD1 Series

Rev. F

CAT-EX-179-01 - Extraction Tool

Date: 8/11/2014

Page 2 of 2

This is a controlled document and is subject to change (printed versions are not controlled)

3. DESCRIPTION

Each tool handle is marked with the tooling number. Make sure it matches the tooling number specified in

this document.

the outside of the housing as shown in Figure 2. The Extraction tool has a tip that is inserted into the

window to depress the lance the correct amount for contact removal.

CAUTION - Do not use any unintended tools to release the lance. This can cause damage to the lance and

weaken its ability to retain the reinserted contact in the housing.

4. EXTRACTION PROCEDURE

The following steps are recommended:

1.

Push the desired lead forward to the bottom of its cavity. This will provide clearance for the lance to

be depressed.

2.

Engage the tip of the Extraction Tool in the lance window as shown in Figure 2. With downward

pressure, push the tool toward the back of the window to release the lance.

3.

Maintain downward pressure on the tool tip then grip the lead and pull the contact from its cavity.

FIGURE 2