To find the best temperature one could start from the lower end of the

recommended settings and increase the bed temperature in 5 °C increments.

This should be done with standardised calibration prints.

An additional benefit of MAGIGOO® - Polycarbonate, being thermally

activated, is that it will release the print upon cooling. Again, different printers,

print surfaces or filaments will have slightly different released conditions but

as a general rule a reduction in temperature of 30-40 °C will be sufficient to

remove your prints without any effort.

The best and most reliable performance is achieved when applied as a thin

layer. This means that cleaning and re-applying between prints is

recommended especially on longer prints or hard to

print with materials.

Storage and Handling:

MAGIGOO® - Polycarbonate, should be stored in a cool dry place away from

direct sunlight. After use MAGIGOO® - Polycarbonate should be stored in an

upright position and with the cap on.

Excess MAGIGOO® - Polycarbonate on the nib can cause the applicator

adhering to the cap. To prevent this, make sure no excess MAGIGOO® -

Polycarbonate remains on the rim of the applicator after use. If not capped

the MAGIGOO® - Polycarbonate applicator will dry up. In such a case just rinse

with water.

3

Press to get adhesive flow

info@magigoo.com

www.magigoo.com

MAGIGOO

Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate

Paola, PLA3000, Malta

2