1161 Ringwood Ct, #110, San Jose, CA 95131, U. S. A. Tel.: (408) 748-9100, Fax: (408) 770-9187

www.analogtechnologies.com

Copyrights 2000-2022, Analog Technologies, Inc. All Rights Reserved. Updated on 1/17/2022

Email: staff@analogti.com/sales@analogti.com

6

Analog Technologies

Low Noise Constant Current Laser Controller

ATLS200MA103

to about 1V or 1.5V, depending on the wavelength of the

laser diode. If we set the lowest output current to a non-zero

value, such as 1/10 of the laser’s operating current but lower

than the laser’s threshold current, the laser’s optical beam can

still be cut

−off, but the output voltage will not oscillate, thus

the output current will not have distortions. The status of the

LIO is similar as the Figure 10 shown without output current

distortions.

t

0

t

0

The laser’s threshold current is shown in Figure 11. It can be

seen that when the laser’s current fall below a certain value,

there is no output optical power. For example, the operating

current and threshold current of a red laser diode of 650nm

are 30mA and 20mA respectively and the optical output

power is 4mW. It will have no optical output power if the

output current of this laser diode is lower than 20mA which is

its threshold current. Figure 12 and Figure 13 will describe