FIGURE 1: SCHEMATIC DIAGRAM

ASSEMBLY CONT.

the amplifier’s pins until the four spacer grommets at the

four corners of the PCB touch the heatsink. At this point

the PCB should not be bowed.

15. Use #8 X 1" sheet metal screws (not provided) to mount

the PCB to the heat sink at the four spacer-grommets.

16. Inspect the assembly from the side and check that the PCB

is not bowed toward the heat sink. If the PCB is bowed use

a small tool to carefully pry the PCB away from the heat

sink until the PCB is flat.

17. Hook up power and signals as necessary. The amplifier

is now ready for testing.

���

���

��

��������������������

�������������������

������������������������

�����������������������

����������������������������

���

��

���

��

���

��

���

��

���

��

��

�

�

�

�

�

��

����

�

��

�

��

�����

��

��

��

��

�����

��

�

��

��

���

��

��

��

��

��

��

��

���

���

���

�

�

�

�

���

��

��

�

�

�

��

��

�

���

���

��

��

���

���

��

��

���

��

��

���

���

���

���

��

��

��

��

���

��

��

���

���

���

���

���

���

�����

���

APEX MICROTECHNOLOGY CORPORATION • 5980 NORTH SHANNON ROAD • TUCSON, ARIZONA 85741 • USA • APPLICATIONS HOTLINE: 1 (800) 546-2739

2

EVALUATION KIT FOR

MP108FD

EK57