6 W DC-DC Converter P6L24xxCx-Series

HY-LINE Power Components Vertriebs GmbH

HY-LINE AG

Inselkammerstraße 10

Hochstrasse 355

D-82008 Unterhaching

CH-8200 Schaffhausen

Tel.: 089 614 503-10

Tel.: 052 647 42 00

E-Mail: power@hy-line.de

E-Mail: info@hy-line.ch

Note:

1.

Min. load should not be less than 5 %, otherwise ripple maybe increased dramatically, If the product operates under min. load, it may not be

guaranteed to meet all specifications listed. Operation under minimum load will not damage the converter.

2.

The recom

mended unbalanced load of dual output converter should be ≤ 5 %. At load asymmetry ≥ 5 %, it may not be guaranteed to meet all

specifications listed.

3.

Maximum capacitive load is tested at input voltage range and full load.

4.

All specifications measured at Ta 25 °C, humidity < 75 %, nominal input voltage and rated output load unless otherwise specified.

5.

It is not recommended to increase the output power capability by connecting two or more converters in parallel

Figure 1

Measure circuit input reflected ripple current

Figure 2

Measure circuit output ripple & noise voltage

Figures 3

Typical application circuit

The P6L series been tested according to the following recommended test circuit before leaving the factory (see Figures 3a & 3b).

If you want to further decrease the input / output ripple, you can increase a capacitance values properly or choose capacitors with low ESR, but the

total capacitance of the filter capacitor must not exceed the maximum load capacitance value (see Model guide table).

Figure 3a

Figure 3b

Page 2 of 5

Recommended peripheral components to figure 3a & 3b

Vin type

Cin

Cout

P6L24xxCS

100 µF, 50 V

22 µF

P6L24xxCD

100 µF, 50 V

2 x 22 µF