AV93LC46PC datasheet(6/9 Pages) ETC1

6 / 9 page

@vic

AV93LC46

Website: http://www.avictek.com

Functional Description (Continued)

Write (WRITE)

The WRITE instruction includes 16 bits of data to be written into the specified register . After the last bit

has been applied to DI, and before the next rising edge of SK, CS must be brought LOW. The falling edge

of CS initiates the selftimed programming cycle.

After a minimum wait of 250ns (5V operation) from the falling edge of CS (tcs), DO will indicate the

READY/BUSY status of the chip if CS is brought HIGH. This means that logical “0” implies the

programming is still in progress while logical “1” indicates the selected register has been written, and the

part is ready for another instruction.(See Figure 6.)

Note: The combination of CS HIGH, DI HIGH and the rising edge of the SK clock, resets the

READY/BUSY flag. Therefore, it is important if you want to access the READY/BUSY flag,not to reset it

through this combination of control signals.

Before a WRITE instruction can be executed, the device must be in the WRITE ENABLE (WEN) state.

Write All (WRALL)

The write All (WRALL) instruction programs all registers with the data pattern specified in the instruction.

While the WRALL instruction is being loaded, the address field becomes a sequence of DON’T-CARE

bits. (Shown in Figure 7.)

As with the WRITE instruction, if CS is brought HIGH after a minimum wait of of 250ns (tcs), the DO pin

indicates the READY/BUSY status of the chip. (Shown Figure 7.)

ERASE (ERASE)

After the erase instruction is entered, CS must be brought LOW. The falling edge of CS initiates the self-

timed internal programming cycle. Bringing CS HIGH after minimum of tcs, will cause DO to indicate the

READY/BUSY status of the chip. To explain this, a logical “0” indicates the programming is still in

progress while a logical “1” indicates the erase cycle is complete and the part is ready for another

instruction. (Shown in Figure 8.)

Erase All (ERALL)

Full chip erase is provided for ease of programming. Erasing the entire chip involves setting all the entire

memory array a logical “1”. (Shown in Figure 9.)

Security Consideration

To protect the entire part against accidental modification of data, each programming instruction (WRITE,

WRALL, ERASE, and ERALL) must satisfy two conditions before user initiate self-timed programming

cycle (the falling edge of CS). One is that the AV93LC46 is at WEN status. The other is that Vcc value

must exceed a lock-out value which can be adjusted by AVIC.

AV93LC46PC bảng dữ liệu(PDF) 6 Page - List of Unclassifed Manufacturers