HiD2872

4

Germany: +49 621 776 2222

Pepperl+Fuchs Group

Refer to "General Notes Relating to Pepperl+Fuchs Product Information".

USA: +1 330 486 0002

Singapore: +65 6779 9091

www.pepperl-fuchs.com

pa-info@us.pepperl-fuchs.com

pa-info@sg.pepperl-fuchs.com

pa-info@de.pepperl-fuchs.com

Solenoid Driver

Switch settings

Configure the device in the following way:

• Push the red Quick Lok Bars on each side of the device in the upper position.

• Remove the device from Termination Board.

• Set the DIP switches according to the figure.

Configuration

Switches for channel I and II

S1

S2

S3

S4

S5

S6

S7

S8

Function

• Bus powered

• Control input: logic signal

• Line fault detection enabled

ON

OFF

ON

OFF

ON

X

ON

ON

• Bus powered

• Control input: logic signal

• Line fault detection disabled

OFF

OFF

ON

OFF

OFF

X

ON

ON

• Bus powered

• Control input: contact

• Line fault detection enabled

ON

ON

OFF

ON

ON

X

ON

ON

• Bus powered

• Control input: contact

• Line fault detection disabled

OFF

ON

OFF

ON

OFF

X

ON

ON

• Loop powered

• Control input: logic signal

• Line fault detection disabled

OFF

OFF

ON

OFF

OFF

X

OFF

OFF

• Loop powered

• Control input: contact

• Line fault detection disabled

OFF

ON

OFF

ON

OFF

X

OFF

OFF

• Loop powered

• Control input: without control

• Line fault detection disabled

OFF

ON

ON

ON

OFF

X

OFF

OFF

Switches for channel I and II

S6

Function

Filter disable

OFF

Filter enable

ON

Factory setting: bus powered, control input: contact, line fault detection enabled, filter disabled

To reduce the power consumption of the device, we recomment to set the DIP switches of channel II

in the OFF condition, when channel II is not used (single channel application).

Configuration