–

–

–

–

20

21

Development Kit Demonstration Software Example

This example shows how to configure two modules to work with each

other. The software defaults to the Demo & EZConfiguration tab when

opened (Figure 21).

Install Carrier Boards onto the Programming Docks and plug a USB cable

between the Programming Docks and the PC. The software automatically

detects attached devices. The first module that is identified appears

under the Active label. This is the module that is actively controlled by

the software. Subsequent modules are listed under the Available label as

shown in Figure 22.

Modules must be paired with the active device. This is accomplished by

dragging modules from the Available or Known Modules lists to the Given

Permissions window as shown in Figure 23.

Figure 21: The Master Development System Software Demo and EZConfiguration Tab

Figure 22: The Master Development System

Software Connected Modules

Once the module is dropped into the Given Permissions window it is

written to the active module’s memory. Clicking on the down arrow displays

the paired module’s Permissions Mask. This configures which output lines

the paired module is authorized to control. In Figure 24 the Permissions are

inactive since the active module only has inputs and no outputs to control.

Figure 24: The Master Development System Software Paired Modules

Figure 23: The Master Development System Software Pairing Modules