STM32G474CB datasheet(48/236 Pages) STMICROELECTRONICS

tên linh kiện	STM32G474CB

Giải thích chi tiết về linh kiện	Arm® Cortex®-M4 32-bit MCUFPU, 170 MHz / 213 DMIPS, 128 KB SRAM, rich analog, math acc, 184 ps 12 chan Hi-res timer

PDF	236 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

48 / 236 page

Functional overview

STM32G474xB STM32G474xC STM32G474xE

48/236

DS12288 Rev 4

3.39

Development support

3.39.1

Serial wire JTAG debug port (SWJ-DP)

The Arm SWJ-DP interface is embedded, and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

Debug is performed using 2 pins only instead of 5 required by the JTAG (JTAG pins could

be re-use as GPIO with alternate function): the JTAG TMS and TCK pins are shared with

SWDIO and SWCLK, respectively, and a specific sequence on the TMS pin is used to

switch between JTAG-DP and SW-DP.

3.39.2

Embedded trace macrocell™

The Arm embedded trace macrocell provides a greater visibility of the instruction and data

flow inside the CPU core by streaming compressed data at a very high rate from the

STM32G474xB/xC/xE devices through a small number of ETM pins to an external hardware

trace port analyzer (TPA) device. Real-time instruction and data flow activity be recorded

and then formatted for display on the host computer that runs the debugger software. TPA

hardware is commercially available from common development tool vendors.

The Embedded trace macrocell operates with third party debugger software tools.

STM32G474CB bảng dữ liệu(PDF) 48 Page - STMicroelectronics