IN SERVICE TOOLS -

AFTER TOOLS HAVE BEEN IN

SERVICE:

It is recommended that each operator of

the tool be made aware of - and

responsible for following these

maintenance steps:

In-service tools should be cleaned and

inspected every 100 cycles. Clean

contact seating punch with a small brush

to remove debris. Wipe with a clean

cloth. Make sure all contact seating

punches are in good condition.

In-service tools should be lubricated

ONCE A WEEK, and after every

cleaning. Lubricate all pins, pivots and

bearing surfaces with a THIN coat of any

good SAE No. 20 motor oil. Do NOT use

oil excessively.

Be sure to clean any excess oil from the

termination area before using.

NEW TOOLS -

BEFORE PLACING INTO SERVICE:

All Panduit termination tools are calibrated

and inspected before they are shipped

from the factory.All new tools should be

inspected before being used.

New tools are shipped, factory lubricated,

in protective packaging.After inspection,

simply clean any excess oil from the

termination area and place into service.

When the tool is not in use, keep the

handles closed to prevent objects from

becoming lodged in the termination area.

Store the tool in a clean, dry area.

INSPECTION / MAINTENANCE

1. Visually inspect the tool for missing or

loose pins, then close the tool and note

the return action of the handles.

2. Ensure that the pins which secure the

termination head are completely seated

and secure.

TERMINATION INSTRUCTIONS

1. Properly wire modular plug. Ensure that the wires fully bottom in the modular plug.

2. With the handles in the open position, insert the modular plug into the opening.

3. Terminate the modular plug by closing the handles until the controlled cycle

mechanism releases. Upon release, the handles will open automatically and the

crimped plug can be removed by gently pulling on the exposed end of the cable.

WARNING

Electric Shock Hazard:

Do NOT use this tool

on live wire.

This tool is not insulated.

When using this tool on or near

energized electrical lines, use proper

personal protective equipment.

Failure to observe this warning

can result in severe injury or death.

MPT5-8AS

CONTROLLED CYCLE

TERMINATION TOOL

FOR MODULAR PLUGS

Part No. MPT5-8AS

OPERATION INSTRUCTIONS

Figure 2

Figure 1

Cushioned Handle

Grips

Termination pocket

Contact

Seating

Punches

© Panduit Corp. 2016

MPT5-8AS

PA26707A01

REV: 02 6-2016

Page: 1 of 1

For Technical Support:

1-800-777-3300

CONTROLLED CYCLE TERMINATION TOOL OPERATION INSTRUCTIONS

3. Inspect the contact seating punches

for worn, chipped or broken edges

and debris.

4. If parts are missing, defective or

damaged, contact your local Panduit

Sales Office for information on repair

or replacement of tools.

VISUAL INSPECTION

E-mail:

techsupport@panduit.com

Controlled Cycle

Mechanism

Prevents tool from

opening before

termination cycle

is complete.

CAUTION:

The cushioned grips are

for user’s comfort and

are not intended to

insulate against shock.

www.panduit.com