SH7041A datasheet(762/923 Pages) RENESAS

tên linh kiện	SH7041A

Giải thích chi tiết về linh kiện	Renesas 32-Bit Single-Chip RISC Microprocessor SuperH RISC engine Family/SH7040 Series(CPU Core SH-2)

PDF	923 Pages

Scroll/Zoom	100%

nhà sản xuất	RENESAS [Renesas Technology Corp]

Trang chủ	http://www.renesas.com

Logo

762 / 923 page

724

22.10

Note on Flash Memory Programming/Erasing

In the on-board programming modes (user mode and user program mode), NMI input should be

disabled to give top priority to the program/erase operations (including RAM emulation).

22.11

Flash Memory Programmer Mode

Programs and data can be written and erased in programmer mode as well as in the on-board

programming modes. In programmer mode, flash memory read mode, auto-program mode, auto-

erase mode, and status read mode are supported. In auto-program mode, auto-erase mode, and

status read mode, a status polling procedure is used, and in status read mode, detailed internal

signals are output after execution of an auto-program or auto-erase operation.

In programmer mode, set the mode pins to PLL x2 mode (see table 22.10) and use a 6 MHz input

clock. The LSI will then operate at 12 MHz.

Table 22.10 shows the pin settings for programmer mode. For the pin names in programmer mode,

see section 1.3.2, Pin Arrangement by Mode).

Table 22.10 Programming Mode Pin Settings

Pin Names

Settings

Mode pin: MD3, MD2, MD1, MD0

1101 (PLL

× 2)

FWE pin

High level input (in auto-program and auto-

erase modes)

RES pin

Power-on reset circuit

XTAL, EXTAL, PLLVcc, PLLCAP, and PLLVss pins Oscillator circuit

Note:

During the programming mode, polarity of the FWP pin is inverted and becomes the FWE

(flash write enable) pin.

SH7041A bảng dữ liệu(PDF) 762 Page - Renesas Technology Corp