LM358ADE4 datasheet(30/61 Pages) TI

30 / 61 page

10.2.3 Application Curve

-2

-1.5

-1

-0.5

0.5

1.5

0.5

1.5

Time (ms)

VIN

VOUT

Figure 10-2. Input and Output Voltages of the Inverting Amplifier

11 Power Supply Recommendations

CAUTION

Supply voltages larger than specified in the recommended operating region can permanently

damage the device (see Section 7.1).

Place 0.1-µF bypass capacitors close to the power-supply pins to reduce errors coupling in from noisy or

high-impedance power supplies. For more detailed information on bypass capacitor placement, see Section 12.

12 Layout

12.1 Layout Guidelines

For best operational performance of the device, use good PCB layout practices, including:

• Noise can propagate into analog circuitry through the power pins of the circuit as a whole, as well as the

operational amplifier. Bypass capacitors are used to reduce the coupled noise by providing low-impedance

power sources local to the analog circuitry.

– Connect low-ESR, 0.1-µF ceramic bypass capacitors between each supply pin and ground, placed as

close to the device as possible. A single bypass capacitor from V+ to ground is applicable for single-

supply applications.

• Separate grounding for analog and digital portions of circuitry is one of the simplest and most-effective

methods of noise suppression. One or more layers on multilayer PCBs are usually devoted to ground planes.

A ground plane helps distribute heat and reduces EMI noise pickup. Make sure to physically separate digital

and analog grounds, paying attention to the flow of the ground current.

• To reduce parasitic coupling, run the input traces as far away from the supply or output traces as possible. If it

is not possible to keep them separate, it is much better to cross the sensitive trace perpendicular as opposed

to in parallel with the noisy trace.

• Place the external components as close to the device as possible. Keeping RF and RG close to the inverting

input minimizes parasitic capacitance, as shown in Section 12.2.

• Keep the length of input traces as short as possible. Always remember that the input traces are the most

sensitive part of the circuit.

• Consider a driven, low-impedance guard ring around the critical traces. A guard ring can significantly reduce

leakage currents from nearby traces that are at different potentials.

LM158, LM158A, LM258, LM258A

LM2904, LM2904B, LM2904BA, LM2904V

LM358, LM358A, LM358B, LM358BA

SLOS068Z – JUNE 1976 – REVISED JULY 2021

www.ti.com

Submit Document Feedback

Product Folder Links: LM158 LM158A LM258 LM258A LM2904 LM2904B LM2904BA LM2904V LM358

LM358A LM358B LM358BA

LM358ADE4 bảng dữ liệu(PDF) 30 Page - Texas Instruments

LM358ADE4 bảng dữ liệu(HTML) 30 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

bảng dữ liệu tải về

Link URL