TUSB217AI datasheet(5/31 Pages) TI

tên linh kiện	TUSB217AI

Giải thích chi tiết về linh kiện	TUSB217A USB 2.0 High-Speed Signal Conditioner With DCP and CDP Controllers

PDF	31 Pages

Scroll/Zoom	100%

nhà sản xuất	TI [Texas Instruments]

Trang chủ	http://www.ti.com

Logo

5 / 31 page

Table 6-1. Pin Functions (continued)

PIN (RWB)

I/O

INTERNAL

PULLUP/PULLDOWN

DESCRIPTION

NAME

NO. (RWB)

RSTN

500 kΩ PU

1.8 MΩ PD

Device disable/enable.

Low – Device is at reset and in shutdown, and

High - Normal operation.

Recommend 0.1-µF external capacitor to GND to ensure clean

power on reset if not driven. If the pin is driven, it must be held low

until the supply voltage for the device reaches within specifications.

SCL(1)/CD

I/O

When RSTN asserted there is

a 500 kΩ PD

In I2C mode:

I2C clock pin [I2C address = 0x2C].

Non I2C mode:

After reset: Output CD. Flag indicating that a USB device is attached

(connection detected). Asserted from an unconnected state upon

detection of DP or DM pull-up resistor. De-asserted upon detection of

disconnect.

(1)

Pull-up resistors for SDA and SCL pins in I2C mode should be RPull-up (depending on I2C bus voltage). If both SDA and SCL are pulled

up at power-up the device enters into I2C mode.

(2)

Pull-down and pull-up resistors for RX_SEN pin must follow RRXSEN1 and RRXSEN2 resistor recommendations in non I2C mode.

www.ti.com

TUSB217A

SLLSFK5 – JUNE 2021

Submit Document Feedback

Product Folder Links: TUSB217A

TUSB217AI bảng dữ liệu(PDF) 5 Page - Texas Instruments