AM652X datasheet(142/282 Pages) TI

142 / 282 page

7.9.2 Power Supply Sequencing

This section describes the power-up sequence required to ensure proper device operation. The power supply

names described in this section comprise a superset of a family of compatible devices. Some members of this

family will not include a subset of these power supplies and their associated device modules.

Note

All timing requirements and switching characteristics in Section 7.9.3 should be strictly followed unless

otherwise specified.

7.9.2.1 Power Supply Slew Rate Requirement

To maintain the safe operating range of the internal ESD protection devices, TI recommends limiting the

maximum slew rate of supplies to be less than 100 mV/μs. For instance, as shown in Figure 7-2, TI recommends

having the supply ramp slew for a 1.8-V supply of more than 18 μs.

Figure 7-2 describes the Power Supply Slew Rate Requirement of the device.

slew rate < 100 mV/ s

slew > (supply value) / (

)

supply value x 10 µs

100 mV/µs

Supply value

SPRSP08_ELCH_06

Figure 7-2. Power Supply Slew and Slew Rate

7.9.2.2 VDDA_1P8_SERDES0 Supply Slew Rate Requirement

To maintain the safe operating range of the internal ESD protection devices, TI recommends limiting the

maximum slew rate of VDDA_1P8_SERDES0 supplies to be less than 40 mV/μs. For instance, as shown in

Figure 7-3, TI recommends having the supply ramp slew for a 1.8-V supply of more than 45 μs.

Figure 7-3 describes the VDDA_1P8_SERDES0 Supply Slew Rate Requirement of the device.

AM6548, AM6528, AM6526

SPRSP52B – DECEMBER 2019 – REVISED JUNE 2021

www.ti.com

142

Submit Document Feedback

Product Folder Links: AM6548 AM6528 AM6526

AM652X bảng dữ liệu(PDF) 142 Page - Texas Instruments